Jelly printing is tremendous fun but it sounds a little frivolous, which is maybe why it’s often described as Printing without a Press or Monoprinting with a Gelatine Plate.

Jelly printing can be a bit random, with no guarantee that you’ll get the print you were expecting, but I think that’s part of the magic. If you use a home-made gelatine plate (we always do) you’ll find that your jelly plate will change over time as tiny holes develop and the plate dries out slightly, which adds texture and interest to your prints.

BEFORE YOU START

Firstly, make a jelly plate using these instructions. The jelly plate is very easy to make, using water, powdered gelatine and glycerine. The only equipment you need are a roller, a palette of some sort to roll out your ink and some water based block or lino printing ink. Use newsprint or copier paper for your first prints.

MAKING YOUR FIRST JELLY PRINTS

jelly print with text Make Your first jelly prints

The best way to start jelly printing is to make a few stencils from a magazine cover. Cut out simple shapes like ovals or circles with a craft knife so that you have a heap of shapes and a piece of paper with lots of holes in it.

Turn your jelly plate out of the container onto the work surface and put your paper (copier paper or newsprint while you’re learning) close to hand. Put a tiny splodge of ink onto your palette, ink up your roller and then roll out a thin layer of ink on the jelly plate. Place your stencil shapes and holey paper onto the jelly plate, lay a piece of paper on top, smooth over with your hands and then peel the paper away.

Jelly printing silhouette print using stencils cut from magazine cover

You have a silhouette print. You will see that where your stencils have masked the ink, nothing has printed, making a silhouette of your stencil.

Carefully remove the stencils, using your fingers or tweezers, lay another piece of paper on the jelly plate and make another print. This is your ghost print. The ink remaining on the plate after the first print was taken together with the ink previously covered by the stencils has been picked up to make a print.

Ink your jelly plate again and repeat the process. Print over your prints with other colours, experimenting with how much you clean your jelly plate between colours.

Jelly Printing layering silhouette print of leaves over stencil ghost prints

Use leaves as stencils and print over your previous ghost prints. Over print silhouette prints of leaves and flowers with more silhouette prints.

WHEN YOU’VE FINISHED

When you’ve finished your session, gently wipe your jelly plate clean with water and a sponge (or wet wipes). If you leave the jelly plate out on the worktop it will dry out, so cover it with cling film or put it into a sealed container and keep in a cool place until you need it next time.

NEXT STEPS

Try different combinations of colour, ghost and silhouette prints. Keep reusing your stencils and plants to see how they retain the ink and add it to subsequent prints. Cut more complicated stencils and use them to build a picture. Lift the ink from the plate with stamping tools to add texture. Discover the detail you get from a ghost print of a leaf.

Come along to one of our Jelly Printing classes at Slamseys. See our website for details of all our printmaking classes.